Shirley Socks

Shirley Socks 


Skills Required/Techniques Used

Knit & purl, cast-on, kitchener stitch/grafting, cables, & working in the round.

Yarn

CYC #1 Super Fine.

Sock shown knit in: 

Knit Picks Stroll (75% Fine Superwash Merino Wool, 25% Nylon); 231 yds/211 m; 1.76 oz/50 g:

MC - Gumball; 1 skein, 40 g,

CC - White; 1 skein, 16 g.

Needles

US 1.5/2.5 mm needles for working small circumference in the round: DPNs, 2 circulars or 1 long circular. 

Or size needed to obtain gauge.

Notions

Stitch markers (M); stitch holder; tapestry needle.

Gauge

32 sts and 44 rnds = 4 in/10 cm square in Stockinette Stitch using US 1.5/2.5 mm needles worked in the round.

36 sts and 44 rnds = 4 in/10 cm square in Slipped Cross Pattern using US 1.5/2.5 mm needles worked in the round.

Size Information

Note: The crossed stitches in the pattern make the fabric tighter than a standard stockinette fabric. Please pick the size that corresponds to your foot circumference which will probably have a greater stitch count than a vanilla sock would for your size.

Sizes

First (second, third, fourth)

Finished Measurements

Sock circumference, not stretched: 6" (7", 8", 9") [15.24, 17.78, 20.32, 22.86 cm]. 

Sock circumference should be approximately 10% smaller than your actual foot/ankle circumference.

Leg length: Adjustable to fit.

Foot length: Adjustable to fit. Finished length should be about ½"/1.3 cm shorter than actual foot length.

The sock shown measures 7"/17.78 cm sock circumference, and 9.75"/24.76 cm foot length.

Stitches

LSC (Left Slip Cross)

Without Cable Needle: Sl1, K1, put left needle through front loop of the second st on the right needle, slip two sts off the right needle, put the right needle through the second stitch from behind the first st, Sl1.

RSC (Right Slip Cross)

Without Cable Needle: K1, Sl1, put left needle tbl of the second st on the right needle, slip two sts off the right needle, put the right needle through the second stitch, Sl1.

Slipped Cross Pattern

Rnd 1: LSC, RSC, K4
Rnd 2: K1, Sl2wyif, Sl2 from right needle, K7
Rnd 3: RSC, LSC, K4
Rnds 4-6: Knit
Rnd 7: K4, LSC, RSC
Rnd 8: K5, Sl2wyif, Sl2 from right needle, K3
Rnd 9: K4, RSC, LSC
Rnds 10-12: Knit


Directions

Cuff

Using US Size 1.5/2.5 mm needles and CC, CO 56 (64, 72, 80) sts using a long-tail or preferred cast on. Distribute across needles as you prefer and join work in the round, being careful not to twist. Place marker or note start of round.

Work *K1, P1* ribbing until the piece measures 1.5"/3.75 cm from CO.

Leg

Break CC. In MC:

Rnds 1-3: Knit.

Knit in Pattern until the piece measures 6.5"/16.5 cm from CO, or desired length to top of heel.

Heel

I have included instructions for a heel flap and gusset but feel free to use any heel you would like. 

This heel is worked back and forth across half of the leg stitches.

Heel Flap

Change to CC.

The heel flap is worked back and forth across 28 (32, 36, 40) sts.

Setup Row: Place the next 28 (32, 36, 40) sts onto a spare needle or holder to work later for instep, turn.

Row 1 [WS]: Sl1, Purl across, turn.

Row 2 [RS]: Sl1, Knit across, turn.

Repeat rows 1-2 for a total of 28 rows, ending with a RS row.

Heel Turn

Row 1 [WS]: SL1, P14 (18, 20, 24), P2tog, P1.

Row 2 [RS]: SL1, K3 (7, 7, 11), SSK, K1.

Row 3 [WS]: SL1, P to 1 stitch before gap, P2tog, P1.

Row 4 [RS]: SL1, K to 1 stitch before gap, SSK, K1.

Repeat rows 3-4 until all heel stitches have been worked, ending with a RS row — 16 (20, 22, 26) sts rem.

Break CC.

Gusset

With MC at BOR,

Setup Rnd: Work instep sts in pattern, PUK 16, K16 (20, 22, 26), PUK 16.

Rnd 1: Work instep sts in pattern, SM, K1, SSK, K to 3 sts before instep, K2tog, K1, — 2 sts dec'd.

Rnd 2: Work rnd even, maintaining patt on instep. 

Repeat Rnds 1-2 a total of 10 (10, 9, 9) times, for a total of 20 (20, 18, 18) rows — 58 (64, 72, 80) sts rem.

Foot

Work as set in Slipped Cross pattern across instep and St st across sole until piece measures 1.5 (1.75, 2, 2.25") / [3.81, 4.45, 5, 5.72 cm] less than the desired foot length.

Toe

Break MC. In CC:

Rnd 1: Knit. 

Rnd 2: K1, SSK, knit to 3 sts before marker, K2tog, K1, SM, K1, SSK, knit to 3 sts before marker, K2tog, K1. — 4 sts dec'd

Repeat rnds 1-2 a total of 8 (9, 11, 12) times, for a total of 16 (18, 22, 24) rows — 20 (24, 24, 28) sts rem.

Break yarn leaving a 12"/30 cm tail.

Kitchener remaining stitches.

Note: When doing the Kitchener stitch don't do the first two setup stitches. Then, when you have one st rem on each needle, slip the st on the front needle off and then slip the st on the back needle off without working them.

Finishing

Weave in the loose ends. Block if desired.


© Alaksya, 2022

Version 1, August 2022

PRINT A COPY/DOWNLOAD PDF

Print Friendly and PDF

Comments

Post a Comment

Popular posts from this blog

Sock Knitting Heel Techniques

Image
Sock Heels These heel patterns are written to work with socks of any number of cast-on stitches. I've separated the heels into four categories based on sock construction:  Cuff-Down French/Round Heel Rounder Heel V/Half Handkerchief Heel Dutch/Square Heel Modified Square Heel German Heel Band Heel Welsh Heel Strong Heel Common Heel Shaped Common Heel Balbriggan Heel Godet Heel Double Gusset Heel Short Row Heel Flap Cuff-Down & Toe-Up Short-row Wrap & Turn Heel German Short Row/Boomerang/Yo Yo/Jo Jo Heel Modified German Short-Row/Boomerang Heel Slipped Yarnover Short-row Heel Shadow Wrap Short-Row Heel Japanese/Pinned Short-Row Heel Priscilla's Wild Short-row Heel Mock Short-Row Heel Combination Heel Toe-Up French/Round Heel Dutch/Square Heel Reverse Dutch/Square Heel Fleegle Heel Afterthought Peasant/Afterthought Heel sädekavenus Heel edeellä Afterthought Tape Heel Short-row Heel
Read more

Classic Cabled Socks Pattern

Image
 Classic Cabled Socks Pattern Skills Required/Techniques Used Knit & purl, cast-on, simple cabling, kitchener stitch/grafting, & working in the round. Yarn CYC #1 Super Fine. Sock shown knit in: Knit Picks Capretta Superwash (80% Fine Superwash Merino Wool, 10% Cashmere, 10% Nylon), 230 yards/210 m, 1.76 oz/50 g: Sagebrush, 2 skeins. Needles US 1.5/2.5 mm needles for working small circumference in the round: DPNs, 2 circulars or 1 long circular.  Or size needed to obtain gauge. Notions Stitch markers (M); stitch holder; cable needle; tapestry needle. Gauge 32 sts and 44 rnds = 4 in/10 cm square in stockinette stitch using US 1.5/2.5 mm needles worked in the round. Size Information Sizes First (second, third) Finished Measurements Sock circumference, not stretched :  7.5" (8.25", 9") [19, 21, 23 cm]. Sock circumference should be approximately 10% smaller than your actual foot/ankle circumference. Leg length:  Adjustable to fit. Foot length:  Adjustable to fit, fin
Read more

Classic Striped Socks Pattern

Image
 Classic Striped Socks Pattern These socks were inspired by classic men's striped socks. The ones you find in your grandmother's knitting pamphlets. I wanted to knit something that felt timeless and would last. I used a heavier fingering weight (4 ply) wool and knit it densely to aid in the life of the sock. I have all of my grandmother's knitting supplies from when the family lived in Alaska and she would knit my father and his siblings mittens, hats and socks, and they bring me constant inspiration. Skills Required/Techniques Used Knit & purl, cast-on, short-rows, kitchener stitch/grafting, & working in the round. Yarn CYC #1 Super Fine. Sock shown knit in:  Patons Kroy Socks (75% Superwash Wool, 25% Nylon); 166 yds/152 m; 1.76 oz/50 g: MC - Grey Marl; 2 skeins, C1 - Muslin; 1 skein. Knit Picks Stroll (75% Fine Superwash Merino Wool, 25% Nylon); 231 yds/212 m; 1.76 oz/50 g: C2 - Black; 1 skein. Needles US 1.5/2.5 mm needles for working small circumference in the r
Read more