Ribbed Beanie

 Ribbed Beanie




Skills Required/Techniques Used

Knit & purl, cast-on, working in the round, & decreasing.

Yarn

CYC #1 Super Fine.

Sample shown knit in: Knit Picks Stroll (75% Fine Superwash Merino Wool, 25% Nylon), 232 yds/214 m, 1.75 oz/50 g, 2 skeins in Navy 

The sample used 65g.

Needles

US 2.5/3 mm - one 16"/40 cm circular needle, and DPNs.

Or size needed to obtain gauge.

Notions

Stitch markers (M); tapestry needle.

Gauge

42 sts and 44 rnds = 4"/10 cm square in 1x1 Rib unstretched using US 2.5/3 mm needles worked in the round.

Size Information

Sizes

Large.

Finished Measurements

Hat circumference, unstretched: 16.75"/42.5 cm

To fit head circumference: 20-23"/51-58 cm

Hat circumference should be approximately 25-35% smaller than your actual head circumference.

Stitches

CDD - Central Double Decrease: Slip next two stitches together as if to knit, knit the next stitch, pass the two slipped stitches over the knit stitch.

Notes

This hat is knit inside out. This creates nice smooth decreases instead of the ridge created on the right side of a CDD.

DIRECTIONS

Using Alternating Long Tail cast-on, CO 176 sts and join in the round, being careful not to twist.

Rnd 1: [K1, P1] around.

Work even until the piece measures 9.5"/24 cm cm from the CO edge, or 3"/7.5 cm less than desired length.

Crown Shaping

Rnd 1: [Work even 21 sts, PM, CDD, work even 20 sts] four times - 8 sts dec'd; 168 sts rem.

Rnd 2: Work even.

Rnd 3: Work even to 1 st bef M, [CDD, work even to 1 st bef M] four times - 8 sts dec'd; 160 sts rem.

Rep Rnds 2-3 nine more times - 72 sts dec'd; 88 sts rem.

Rep Rnd 3 ten more times - 80 sts dec'd; 8 sts rem.

Finishing

Break the yarn leaving a 12"/30.5 cm tail. With a tapestry needle, thread the tail through the remaining stitches. Pull end closing the hole and secure the tail outside the hat.

Weave in ends on the outside of the hat. Turn the hat inside out.




Print Friendly and PDF

Comments

Post a Comment

Popular posts from this blog

Diamond Shorty Socks Pattern - With Shadow Wrap Heel

Image
 Diamond Shorty Socks Pattern - With Shadow Wrap Heel Finished Size Ankle/Foot circumference, un-stretched: 8" (20cm). Un-stretched size should be about 1" (2.5cm) smaller than your foot circumference. Leg length: Adjustable to fit. Foot length: Adjustable to fit, finished length should be about ½" (1.3cm) shorter than actual foot length. Sock shown measures 8" ankle/foot circumference. Yarn CYCA #1 Super Fine. Sock shown used approximately 45g/208yd/190m of 75% Superwash Merino, 25% Nylon fingering weight yarn. Needles US 1 (2.25 mm) or size needed to obtain gauge. Notions Markers (m); tapestry needle. Gauge 32 sts and 44 rnds = 4" (10cm) in St st worked in rnds. Stitches Diamond Lace Stitch Rnd 1: [YO, SSK, K3, K2tog, YO, K1] repeat around. Rnd 2, and all even rnds: Knit. Rnd 3: [K1, YO, SSK, K1, K2tog, YO, K2] repeat around. Rnd 5: Knit. Rnd 7: [K1, K2tog, YO, K1, YO, SSK, K2] repeat around. Rnd 9: [K2tog, YO, K3, YO, SSK, K1] repeat around. Rnds 10-12: Knit...
Read more

Silly Goose Socks

Image
 Silly Goose Socks DOWNLOAD PDF PATTERN Skills Required Casting on, knitting in the round, increasing, decreasing, stranded colorwork from chart, short rows, and kitchener/grafting. Sizes  Recommended ease: No ease. Leg / Foot Length: Adjustable. Yarn Any CYC Super Fine #1, Fingering weight sock yarn can be used as long as you obtain the recommended gauge. Sample was knit in: Cascade Yarns 'Heritage Sock' (75% Superwash Merino Wool, 25% Nylon), 437 yd / 400 m per 100 g; 1 skein each:    MC: 5713 (Placid Blue)    CC1: 5682 (White)    CC2: 5644 (Lemon) Needles US 1 / 2.25 mm and US 1.5 / 2.5 mm needles for working a small circumference in the round: DPNs, 9" circular, 1 long circular, or 2 short circulars.  Or sizes needed to obtain gauge. Notions Stitch markers, scissors, tapestry needle. Gauge 34 sts x 44 rows to 4" / 10 cm on US 1 / 2.25 mm needles for ribbing and stockinette, after blocking; on US 1.5 / 2.5 mm needles for c...
Read more

Sock Knitting Heel Techniques

Image
Sock Heels These heel patterns are written to work with socks of any number of cast-on stitches. I've separated the heels into four categories based on sock construction:  Cuff-Down French/Round Heel Rounder Heel V/Half Handkerchief Heel Dutch/Square Heel Modified Square Heel German Heel Band Heel Welsh Heel Strong Heel Common Heel Shaped Common Heel Balbriggan Heel Godet Heel Double Gusset Heel Short Row Heel Flap Cuff-Down & Toe-Up Short-row Wrap & Turn Heel German Short Row/Boomerang/Yo Yo/Jo Jo Heel Modified German Short-Row/Boomerang Heel Slipped Yarnover Short-row Heel Shadow Wrap Short-Row Heel Japanese/Pinned Short-Row Heel Priscilla's Wild Short-row Heel Mock Short-Row Heel Combination Heel Toe-Up French/Round Heel Dutch/Square Heel Reverse Dutch/Square Heel Fleegle Heel Afterthought Peasant/Afterthought Heel sädekavenus Heel edeellä Afterthought Tape Heel Short-row Heel ...
Read more